James Dulley, Published August 06 2010
Two options available to keep your house cool
Dear Jeff: Your situation with no heating duct system is not uncommon in older homes throughout the country, especially in hot or cold climates. In cold climates, boilers and other non-ducted heating systems are common. In hot climates, one or two small space heaters or floor furnaces are all that is needed for heating.
You have basically two options to cool your entire house: a mini-duct system and a mini-split system. A mini-duct system has cooling air outlets (registers) in every room, whereas a mini-split system has cooling air circulators in just several rooms. The cool, dehumidified air from the circulators will flow throughout your home, but there may be uneven temperatures and the noise level is higher than with a mini-duct system.
A mini-duct system is easy to install inside the walls with minimal remodeling. The small ducts fit inside a typical framed wall without having to disturb the drywall. Trying to install standard metal ducts with an outlet in every room is difficult, especially in two-story homes. Unico’s mini-duct blower is modular, so it also installs easily in the attic.
The mini-duct system has some comfort and overall efficiency advantages over a standard ducted air-conditioning system. Both systems use a high-efficiency outdoor compressor unit, but the mini-duct system operates at a much higher air pressure. This high pressure is needed to force the cooling air through the small insulated ducts.
Since the blower operates at a high pressure, dense cooling coils, which would create too much air flow resistance for a standard ducted blower system, can be used. These dense coils keep the room air in contact with them longer to increase the amount of dehumidification by up to 30 percent. If indoor is dehumidified, you can feel comfortable at a higher temperature, therefore saving energy.
There are generally several mini-ducts run to each room. These terminate at 2-inch-diameter outlets typically mounted up near or in the ceiling. With several outlets in each room, the cool air is distributed well throughout each room. Wide, but narrow, outlet registers are also available for mounting under cabinets or where there are other space constraints.
The cool air blows out of the outlets at a high velocity. This creates a vortex effect, which draws room air into the flow for excellent mixing. Even though the cool air blows out at a high velocity, the system operates very quietly.
The main blower and heat exchanger unit is often mounted in the attic with a larger insulated truck duct running almost the length of the attic. The insulated room ducts run off this trunk duct or from other secondary smaller trunk ducts to the room outlets.
The following companies offer mini-duct central systems: Comfortpro Systems, (800) 968-8905, www.comfortprosystems.com; Energy Saving Products, (888) 652-2219, www.hi-velocity.com; Mestek, (413) 564-5530, www.spacepak.com; and Unico, (800) 527-0896, www.unicosystem.com.
Dear Jim: I have a good source of firewood from so many ash trees being killed by emerald green ash borers. I would like to design a fireplace with openings on both sides to heat two rooms. Can I do this myself? – Mike L.
Dear Mike: I lost five ash trees in my own yard during the past year. Wood-burning fireplaces can be built with openings on both sides, but I would not recommend designing it yourself. The relationship of the dimensions is critical to create a strong chimney draft. Let a professional design it.
If you want to design and build it yourself, make one with just a standard opening on one side. Install vents through the wall so heated air will circulate to the adjacent room.
Send inquiries to James Dulley, The Forum of Fargo-Moorhead, 6906 Royalgreen Drive, Cincinnati, OH 45244, or visit www.dulley.com.